AC Installation in San Antonio, TX
A new air conditioner is a serious call in a climate this demanding. We size the system to your actual home and install it to hold up through San Antonio summers, not just to swap out a box.
Correct sizing is everything here. An oversized unit short-cycles, never runs long enough to wring humidity out of the air, and leaves the house cold and sticky, while an undersized one runs nonstop and still loses the fight in August. We run a real load calculation based on your square footage, insulation, windows, and ductwork instead of just matching whatever was there before.
San Antonio homes vary wildly, and the right system depends on which one you have. A 1920s bungalow in Monte Vista or King William often has original, undersized returns and no easy path for new ducts, while a newer build up in Stone Oak or out in the far-northeast suburbs has more capacity to work with but bigger open volumes to cool. We match the equipment and the airflow plan to your specific house, not a one-size template.
We walk you through the choices that actually move the needle: single-stage versus two-stage or variable-speed cooling, the SEER2 efficiency rating, and whether a variable-speed blower is worth it for humidity control. Higher efficiency costs more upfront but pulls down those long CPS Energy summer bills month after month, and here the cooling runs most of the year.
The install is where quality shows. We set the condenser on a level pad, pull a proper vacuum on the line set, weigh in the charge, and verify airflow and temperature split before we call it finished. We also account for our hard water, choosing components and drain routing that hold up better against the mineral scale that shortens coil and drain life in this region.
What's included in a new AC installation
- In-home load calculation and honest system sizing
- Options for single-stage, two-stage, and variable-speed equipment
- SEER2 efficiency guidance matched to your budget
- Proper line-set vacuum, weighed-in charge, and airflow verification
- Ductwork and return assessment for older and newer homes alike
- Haul-away of your old equipment
Other services
Frequently asked questions
How do I know what size AC my house needs?
We run a load calculation covering your square footage, insulation, windows, ceiling height, and ductwork. Bigger is not better in San Antonio, an oversized unit short-cycles and leaves the home humid, so we size it to match how your home actually gains heat.
My house is an older downtown home, does that change the install?
Often, yes. Many historic inner-loop homes have undersized returns and tight spots for ducting, so we assess airflow and may recommend return or duct improvements alongside the equipment. Getting that right is what makes an older home actually cool evenly.
What SEER2 rating should I choose?
It is a trade-off between upfront cost and monthly savings. Because our cooling season runs most of the year, a higher-efficiency system pays you back faster here than it would in a cooler climate. We show you the options and let you pick.
Do you remove my old system?
Yes. We haul away and dispose of the old equipment and clean up the work area before we leave.
Need service today?
Call now for fast, friendly service across San Antonio, TX.